Instructions For Use - TurMix A31150 Platinum Mode D'emploi

Instructions for use

important
The device must be unplugged to remove / change the accessories.
or
2
1
3
+
–
Insert the kneading helices or double whisks
Put the attachments in the openings until they lock into place with
a clicking noise. Due to the special construction of the openings
you can only put the kneading spirals in one of the openings. If one
of the kneading spirals cannot be inserted, choose the other open-
ing. Remove the attachment by pressing the release button. The
attachment slides from the opening due to its own weight.
Insert the hand blender and knife
Turn the base at the back of the device in an anti-clockwise direc-
tion until it stops and then pull it out. Push the blender attachment
into the opening as far as possible and secure it by turning it clock-
wise into the plastic ring until it can no longer be turned. Press the
knife attachment into it. Make sure the driving pins are properly
plugged into the slot. The blender and knife attachment can be re-
moved by following these steps in a reversed order.
Turn the device on / off
Plug it in before using it. Turn the device on by turning the switch
to the desired setting. Start with the lowest speed setting and then
slowly increase the speed. Turn the device off and unplug before
emptying the contents or adding more ingredients. Let the device
cool down before storing it.
Instructions for use
EN
55