Installing Your Cigar Humidor - Eurocave CC064V3 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5 - I
Unpacking
Check, when your humidor is delivered, that it does not have any
external faults (impact, warping...).
Open the door and check the integrity of the inside of your appliance
(walls, sliding shelf, sliding drawer, hinges...).
Remove the protective packing inside the humidor.
If there is a problem, contact your EuroCave dealer.
Précautions
Do not place your humidor in an area likely to be flooded.
Do not position your humidor near to a source of heat or expose it to
the effects of direct sunlight.
Prevent water from splashing on the entire rear section of the appliance.
Position your appliance so that there is a minimum space of 5 – 10 cm
between the wall and the rear wall of your cabinet.
If you are positioning your humidor under a work surface, leave a
minimum space of 5 cm all around the appliance including under the
work surface.
Allow for a ventilation grill on the work surface
(recommended).
Arrange the power lead so that it is accessible and does not come into
contact with any component of the appliance..
Slightly tilt the humidor backwards to adjust the front feet (adjusted by
screwing or unscrewing), so that you can level your cabinet (use of a
spirit level is recommended).
Verify that the plastic tube of the drain pipe, located inside your humidor,
in the lower part on the left-hand side is positioned correctly (see
diagram below).
18
EN
NSTALLING YOUR CIGAR HUMIDOR
Installation
Transport your humidor to the chosen location.
It must:
be open on the outside to allow air to circulate (not a closed
cupboard...)
not be too damp (laundry room utility room, bathroom...),
have a stable, flat floor,
have a power supply (standard socket, 16 A, earthed with circuit
breaker, 30 mA* (*not applicable to some countries).
Then place the three clay granule cassettes in the tank at the bottom of
the apparatus and connect them together using the snugs.
Install the carbon filter, which you will find inside your humidor's
"accessories" box, by placing it in the air circulation hole located inside
the humidor on the top left hand side (see diagram below).
For the first use, the carbon filter alarm will be displayed. Reset the filter
counter to 365 (see chapter 7, § IV).

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cc064v2

Table des Matières