Transmitter Batteries; Charging Your Transmitter - Spektrum DX18 Manuel D'utilisation

TRANSMITTER BATTERIES

Battery and Charging Precautions and Warnings
Failure to exercise caution while using this product and comply with the following warnings could result in product malfunction,
electrical issues, excessive heat, FIRE, and ultimately injury and property damage.
• Read all safety precautions and literature prior to use of this product
• Never allow minors to charge battery packs
• Never drop charger or batteries
• Never attempt to charge damaged batteries
• Never attempt to charge a battery pack containing different types
of batteries
• Never charge a battery if the cable has been pinched or shorted
• Never allow batteries or battery packs to come into contact with
moisture at any time
• Never charge batteries in extremely hot or cold places (recom-
mended between 50–80 degrees F or 10–27 degrees C) or place
in direct sunlight

Charging Your Transmitter

The DX18 has an internal charger designed to charge the
included 2-cell LiPo battery at a charge rate of 200mAh. The
charge port on the right side of the transmitter is not polarity-
dependent.
NOTICE:
Never connect an external battery charger to your
DX18 transmitter. If you wish to charge the LiPo battery using a
LiPo charger, you must remove the battery from the transmitter
before charging.
The fi rst time you charge the transmitter battery, the charge time
may be 12-15 hours. Always charge the transmitter on a heat
resistant surface.
1. Power off your transmitter.
2. Connect the power supply connector to the transmitter
charge port.
3. Connect the power supply to a power outlet using the appro-
priate adapter.
4. The blue LED on the front of the transmitter turns on during
charging and turns off when the battery is fully charged.
5. Disconnect the transmitter from the power supply once
charging is complete and disconnect the power supply from
the power outlet.
CAUTION:
Never leave a charging battery unattended.
SPEKTRUM DX18 • TRANSMITTER INSTRUCTION MANUAL
• Always disconnect the battery after charging, and let the charger
cool between charges
• Always inspect a new battery before charging
• Always terminate all processes and contact Horizon Hobby if the
product malfunctions
• Always keep batteries and charger away from any material that
could be affected by heat (such as ceramic and tile), as they can
get hot
• Always end the charging process if the charger or battery be-
comes hot to the touch or starts to change form (swell) during the
charge process
LED indicators
The blue LED indicates the transmitter battery is charging. The
orange LED indicates the transmitter is powered on and there is
radio transmission.
Battery Alarm
The System Settings Screen allows you to change the battery
type and low alarm settings. See "System Settings" for more
information.
• An alarm will sound when the battery reaches the low volt-
age limit (4.3V for NiMH, 6.4V for LiPo).
CAUTION:
Never change the low voltage limit for LiPo
batteries from 6.4V. Doing so could over-discharge the
battery and damage both battery and transmitter.
EN
5