MRA 4025066167173 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
1 Reinforcing plate
4 Neoprene washer 16x4.5x4mm
4 Lens head screws, M5x20mm
2 O-rings, 4.5x1.5mm
4 Plastic discs 12x5x0.5mm
1 Edge protection strip with clamping
sleeves
Fitting the fairing screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Dismantle the original screen (P1).
3. Insert the supplied M5X20mm fillister head screws with the plastic washers into the
lower and upper holes. Push the supplied rubber spacers against these from behind
(P2)
4. Place the supplied reinforcing plate onto the upper screws and secure the plate with
the supplied O-rings (P3).
5. Attach the MRA windscreen with the reinforcing plate to the motorcycle.
Tip: First, screw all fastening screws into the holes for a few thread lengths;
then, fully tighten the screws.
6. Pull the edge protection strip to the rear end of the screen. The clamping sleeves are
stuck onto the ends and pushed together slightly, so that the edge protection strip is
stuck to the screen.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
BMW R1250R 2019-
Article No..
--- Allen key 3mm
Torx 25
11409
10634
10673
10992
10635
---
3
Required tools