Table des Matières
Publicité
MultiSystem 5060
Mode d'emploi
6.9.4
Define scaling
As a standard, the complete measuring range of a variable is used as scaling.
If you want to limit the presentation to a certain part of the measuring range,
you may enable the manual scaling:
1. Select „Type scaling":
2. Select „MANUAL":
3. Select „Scaling":
Here you may set the minimal and maximal values of the measured values to
be presented. Here for "p1" and "Q1" tie complete measuring range (0 – 200
bar, resp. 0 – 300 l/min) shall be presented, For "p2" only measured values
shall be presented that are between 40 and 100 bar. This is how to change the
scaling of a variable:
1. Select variable:
2. Enter minimal value, e.g.:
3. Enter maximal value, e.g.:
4. Save scaling and close the screen:
You may use the function keys to ease the manual scaling:
loads the measuring ranges of the variables and shows them as scal-
ing
checks the measured values of all variables and shows the used
measuring ranges as scaling
checks the measured values of the highlighted variable and shows the
used measuring range as scaling
6.9.5
Define size
As a standard, series of measurement are presented completely. But you may
limit the range of presented values by entering a start and end time. In the
shown example, the range between 2.5 and 5.0 seconds will be presented,
only. This is how to set the range of presentation:
1. Select „Size":
2. Select „Clipping":
3. Enter start time "From", e.g.:
4. Enter end time "To", e.g.:
6.9.6
Type de représentation: tableau
Independant of the recording time, a table will always contain eleven lines.
Start and end value, together with nine intermediate values. You may "zoom"
into the table to display intermediate values between two displayed values:
1. Press
.
2. Use
to highlight the line beneath that you want to display intermediate
values.
3. Press
; the highlighted value becomes the start and the next the end
value, between that nine intermediate values are displayed.
Now you may repeat these steps to show more detailed values, or press
to undo the "zooming" step-by-step.
© Hydrotechnik GmbH • Tous droits réservés
Rev. 1.6/100927FR
Page 33 à 47
Publicité
Table des Matières
