Installation - Sefa iSPRAY PRO Manuel De L'utilisateur

a� Unboxing
First remove the top cover from the carton box.
Then remove the protective styrofoam sheets.
Continue with removing the side carton cover.
The product is 104Kg and requires at least 4 people to lift it. Always carry the device
from the bottom. Never lift it utilizing the drawer handle, nor the Nozzle Access Cover.
Place this product on a flat, stable surface. The surface should be at least 670 x 790 mm
and capable of supporting more than 130kg. This product will not operate properly if it
is tilted or in an angle. The machine must only be used indoors. Do not install or store
the iSPRAY Pro, where it will be exposed to weather conditions. Avoid places subject to
shocks and vibrations. Before moving the machine to another position, ensure that the
tank caps are sealed and liquid cannot spill out. Do not tilt the pretreatment machine,
while the liquid tanks are full or inside the machine.
b� Preparation
Remove the blue security tapes from the iSPRAY Pro covers.
Open the Nozzle Access Cover.
Remove the yellow safety bar from the Nozzle Carriage.
Open the drawer and check that the table is properly placed on it.
The height of the machine on the front side must be 660mm and on the backside
643mm. If not, adjust the feet accordingly.
www.sefa.fr

INSTALLATION

TO BE PERFORMED BY QUALIFIED PERSONNEL
Keep the machine away from direct sunlight and heat sources
User guide - SEFA iSPRAY PRO
7