First Start - Sefa iSPRAY PRO Manuel De L'utilisateur

2021-03-25
a� Preparation
Plug in the power cord. Make certain that the source voltage is the same as the rated
voltage, listed on the serial number/rating plate. Power On the machine from the Main
switch, that is placed at the backside of iSPRAY Pro.
b� Nozzle assembly steps
Place inside the Nozzle Carriage Chamber the nozzle assemblies, following the steps
below :
1. Open the Nozzle Access Cover
2. Insert the nozzle inside the blue nozzle holder.
3. Position the black gasket inside the blue nozzle holder and push it, in place, to tighten.
Finally, Attach the nozzle assembly to the carriage and turn it 90 degrees counterclo-
ckwise to lock it in position.
c� Initial Liquid Charge
To initiate the machine, tap the screen.
Check that the CL, L1 and/or L2 Tanks are full and that all four (4) nozzles are properly
placed into position.
Press Confirm to continue with the liquid charge.
In case you installed pretreatment liquid in L1 or L2 Tank, select the one you filled.
In case you installed pretreatment liquid in both L1, L2 Tanks, select the one you wish to
use first and press Confirm.
10

FIRST START

www.sefa.fr