Sefa iSPRAY PRO Manuel De L'utilisateur page 19

d� Monthly Maintenance
Check and clean the L1, L2 tank filters :
1. The two filters are located in the Tank Compartment.
2. Unscrew the filter cap to remove them.
3. Clean them with water.
4. Reposition them. Make sure they are, in their initial place.
There is no need to empty the tubes from liquid to do this procedure.
Clean the Liquid Collecting Mat :
1. Open the Nozzle Access Cover.
2. Remove the Liquid Collecting Mat.
3. Clean it with water.
4. Reposition it. Make sure it is, in its initial place.
e� Two Month Maintenance
Check and clean the Nozzle Filter :
The 3rd filter (nozzle filter) is located in the Nozzle Carriage Chamber. To clean it, you
need to, firstly, discharge the liquid from the main tube. To do that, you have to bring
the machine to service condition. For further instructions, check the topic: Service
Condition in the Operational Manual.
When iSpray Pro is in service condition, you can safely remove the filter cap and take it
out to be cleaned.
Clean the Waste Collector :
1. Power Off the machine, from the Main Power switch before cleaning the Waste
Collector.
2. Open the Nozzle Carriage Cover and pull it outwards.
3. Remove the screws holding the left metal cover and pull it out.
4. Remove the top plastic cover of the Isolation Chamber.
5. Clean the Waste Collector with paper or a towel.
6. Place back, into initial position, the top plastic cover of the Isolation Chamber.
7. Place the screws back on the left metal cover and tighten it into place.
8. Move the Nozzle Carriage back to Home position and close the Nozzle Carriage Cover.
www.sefa.fr
User guide - SEFA iSPRAY PRO
19