Sefa iSPRAY PRO Manuel De L'utilisateur page 20

2021-03-25
f� Long Inactivity Maintenance
Storage Condition :
1. Empty the L1, L2 Tanks from the pretreatment liquid.
2. Fill the L1, L2 Tanks with distilled water.
3. Check that the CL Tank is full of / contains distilled water.
4. In one step: On the Home screen, tap on the Menu Button and then, select
Tanks.
5. Perform a Liquid Charge, by selecting L1, L2, CL, one-by-one, in any order. This
will flush all the lines with distilled water.
6. Go back and in the main Menu screen, tap on Service.
7. Set the Initial Charge Flag to ON.
8. Tap on the back icon and select the Shutdown button.
9. Click Yes to flush with distilled water the main line and nozzles.
10. When finished, iSpray Pro will Shutdown. Close the main switch at the back of
the machine and remove the power cable.
11. Remove the 4 nozzles from the Nozzle Carriage.
12. Place the 4 nozzles in the ultrasonic device.
13. Clean the Waste Collector, as described on page 23.
14. Empty all Tanks from liquids and place them back, empty. Place the tubes back
into the Tanks and seal the caps.
When the machine has been maintained for Long Inactivity Storage Condition,
To restore iSPRAY Pro after the Long Inactivity- Storage Condition state, follow the
g� Transporting iSpray Pro
Before moving the machine to another location/position, ensure that the tank caps
are in place and sealed, so liquid cannot spill out. Do not tilt iSpray Pro while the
liquid tanks are full or inside the machine and the waste collector is not properly
cleaned.
Perform the Maintenance Long Inactivity Storage Condition.
For further information check the topic: Maintenance>Long Inactivity> Storage Condi-
tion.
1. Lock the Nozzle Carriage in position with a tire up.
2. Ensure that the Tanks are empty.
3. Place tape to all covers to keep them properly secured into place.
20
there is no need to follow up with the maintenance schedule.
instructions in the Installation Guide.
www.sefa.fr