Sony STR-DE375 Mode D'emploi page 11

1
Press one of the Function buttons to select the
component you want to use.
The Function buttons on the remote are factory-
set as follows:
To listen or to watch
Radio programmes
Compact discs (CD)
MiniDisc (MD) or
Audio tapes
TV programmes or
Satellite receiver
VHS Video tapes
(VTR-3 mode)
DVD player/
Dolby Digital decoder
with MULTI CH OUTPUT
* VIDEO 1, VIDEO 2, VIDEO 3, PHONO and MD/
TAPE function is a 2-key operation. To select the
above function, press FN SHIFT (function shift) and
the function key you want simultaneously.
For example, press FN SHIFT and CD/SACD to
select MD/TAPE function.
If you want to change the factory setting of a
button, see the next section.
The receiver and the selected component turn on.
If the component does not turn on
Press the power switch on the component.
2
Start playing.
Refer to "Remote Button Descriptions" on page 26
for details.
Changing the factory setting of a
function button
If the factory settings of the FUNCTION buttons don't
match your system components, you can change them.
For example, if you have an MD player and a tape deck
and you don't have a CD player, you can assign the
CD/SACD button to your tape deck.
Note that the settings of the TUNER and FN SHIFT
functions (VIDEO 1, VIDEO 2, VIDEO 3, PHONO and
MD/TAPE) cannot be changed.
1
Hold down the Function button whose function
you want to change (for example, CD/SACD).
2
Press the corresponding button of the component
you want to assign to the Function button (for
example, 4 - Tape Deck).
Press
TUNER
CD/SACD
MD/TAPE and FN SHIFT*
(INITIAL-MD MODE)
TV/SAT
(INITIAL-TV MODE)
VIDEO
DVD/LD
(INITIAL-DVD MODE)
Receiver Operations
Numeric
buttons
> 10
.
The following buttons are assigned to select the
functions:
To operate
CD player
DAT deck
MD deck
Tape deck A
Tape deck B
LD player
VCR (remote control mode VTR 1*)
VCR (remote control mode VTR 2*)
VCR (remote control mode VTR 3*)
TV
DSS (Digital Satellite System)
DVD
VCD player
* Sony VCRs are operated with a VTR 1, 2 or 3 setting.
These correspond to Beta, 8mm and VHS respectively.
Now you can use the CD/SACD button to control
the tape deck.
To reset a button to its factory setting
Repeat the above procedure.
To reset all the function buttons to their factory setting
Press ?/1, AV ?/1 and MASTER VOL – at the same time.
AV ?/1
?/1
Function
buttons
ENTER
MASTER VOL –
Press
1
2
3
4
5
6
7
8
9
0
> 10
ENTER
.
11 GB