Ac Hookups - Sony STR-DE375 Mode D'emploi

Getting Started
To avoid short-circuiting the speakers
Short-circuiting of the speakers may damage the
receiver. To prevent this, make sure to take the
following precautions when connecting the speakers.
Make sure the stripped ends of each speaker cord does
not touch another speaker terminal or the stripped end
of another speaker cord.
Examples of poor conditions of the speaker cord:
Stripped speaker cord is touching another speaker
terminal.
Stripped cords are touching each other due to excessive
removal of insulation
After connecting all the components, speakers and AC
power cord, output a test tone to check that all the
speakers are connected correctly. For details on
outputting a test tone, refer to "Adjusting the speaker
volume", on page 19.
If you have connected surround speakers, be sure to
press the DVD/MULTI CH button and turn off sound
field on the receiver before outputting a test tone so
that the tone is output individually from the left and
right surround speakers.
If no sound is heard from a speaker while outputting a
test tone or a test tone is output from a speaker other
than the one whose name is currently displayed on the
receiver, the speaker may be short-circuited. If this
happens, check the speaker connection again.
8 GB
R
L
+
–
R
L
+
–
Active woofer
Active Woofer
Receiver
INPUT
AUDIO OUT
SUB
WOOFER
Note
Do not connect any other component.
If your TV monitor uses separate speakers
You can connect one of them to the SPEAKERS
CENTER terminals for use with Dolby Pro Logic
Surround sound (see page 18).
Where do I go next?
To complete your system, go to "AC Hookups" on this page.

AC Hookups

Connecting the mains lead
Connect the mains lead from this receiver and from
your audio/video components to a wall outlet.
Where do I go next?
Before you use the receiver, go to the next section to make
sure that all the controls are set to the appropriate positions.
,
to a wall outlet