Before First Use - Zanussi ZDT24003FA Notice D'utilisation

While the drying phase operates, the
device opens the appliance door. The
door is then kept ajar.
By default, AirDry is activated with all programmes
excluding (if applicable), but it is possible to
deactivate it.
Make sure the appliance is in user mode.
1. Press .
The indicators:
The indicator still flashes.

BEFORE FIRST USE

1. Make sure that the current level of the
water softener agrees with the hardness
of the water supply. If not, adjust the level
of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any processing
residuals that can still be inside the appliance.
Do not use detergent and do not load the
baskets.
After starting a programme, it may take up to 5
minutes for the appliance to recharge the resin in
Adding salt
Before the first use, put one litre of water in the salt container.
CAUTION! Water and salt can come out of the salt container during filling. To prevent
corrosion, start a programme immediately after filling the salt container.
8
and are off.
The indicator indicates the current setting. If
on = AirDry is on, if off = AirDry is off.
2. Press to change the setting.
3. Press on/off to confirm and save the setting.
CAUTION! If children have access to
the appliance, it is advised to
deactivate AirDry as opening the door
may pose a danger.
the water softener. It seems that the appliance is
not working. The washing phase starts only after
this procedure is completed. The procedure is
repeated periodically.
THE SALT CONTAINER
CAUTION! Use rough salt designed
for dishwashers only. Fine salt
increases the risk of corrosion.
The salt is used to recharge the resin in the water
softener and to assure good washing results in
daily use.