System Requirements; Declaration Of Conformity; Safety Regulations - Holmatro HSS 200 Mode D'emploi

1.5.2 Practicability
The life span and the practicability of the system strongly depend on various conditions, such as the
intensity of use and the shape and the weight of the load. In any case of doubt about the practicability or
the life span of this system, please contact Holmatro.
1.5.3

System requirements

Because the controls, the operating pressure and the required oil volume may vary per tool, this system
is not compatible with all Holmatro pumps, hoses or tools. Always contact the Holmatro dealer in case
of any doubt about the compatibility of the system. Because of the universal field of application of the
tool, not all system combinations can be described. Make sure you use the correct accessories, such as
(check) valves or valve blocks.
1.6 Qualified personnel
The system may only be operated by people trained in its use. Always obey local legislation, safety and
environmental regulations. Repair work may only be performed by a Holmatro Certified Technician.
1.7 Guarantee
Refer to the general terms and conditions of sale for the guarantee conditions, available from your
Holmatro dealer on request.
Holmatro draws your attention to the fact that every guarantee on your piece of equipment or system
will lapse and that you must indemnify Holmatro against any possible product liability and responsibility
if:
• service and maintenance are not carried out strictly in accordance with the instructions, repairs are
not performed by a Holmatro Certified Technician or are performed without prior written consent;
• self-made changes, structural changes, deactivation of safety devices, injudicious adjustment of
hydraulic valves and faulty repairs have been carried out;
• non-genuine Holmatro parts or lubricants other than the types prescribed are used;
• the piece of equipment or the system is used injudiciously, through errors of operation, improperly,
negligently or not in accordance with its nature and/or purpose.
1.8

Declaration of Conformity

The equipment is CE certified. It means that the equipment complies with the essential requirements
concerning safety. The original Declaration of Conformity is supplied with the equipment.
The standards and directives that have been taken into consideration in the design are listed in
section Technical Specifications in this document.
2

Safety regulations

2.1 Explanation of the symbols used in this manual
In this manual the symbols below are used to indicate possible dangers.
DANGER
Indicates an imminently hazardous situation which, if not avoided, will result in death or
serious injury.
WARNING
Indicates a potentially hazardous situation which, if not avoided, could result in death or
serious injury.
HSS 200 916.001.096_005
EN
23