Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Connect the couplers and check whether the coupler locks automatically. Check the locking by
pulling the hoses apart with a normal manual effort. The couplers must not slip.
•
Disconnect the couplers by turning the locking ring and pulling it backwards.
•
Connect and disconnect the couplers a few times to improve the internal lubrication of the locking
system.
8.6.3
Dust caps
•
Check the dust caps for damage. Replace damaged dust caps.
•
Clean the dust caps with running water. Dry the dust cap and treat it with preservative oil.
8.6.4
Piston
•
Check the piston for damage. Have a Holmatro Certified Technician replace a damaged piston.
8.6.5
Bleed the cylinder
•
Put the cylinder on its side. Make sure that the couplers are facing upward.
•
Extend the plunger two or three times and retract it again.
8.6.6
Push/pull unit, push pawls or blocking pawls
•
Check the push/pull unit and the push pawls or blocking pawls for damage. Have a Holmatro
certified technician replace damaged parts.
•
Clean the push/pull unit and the push pawls or blocking pawls by washing them with running water.
Dry the push/pull unit and the push pawls or blocking pawls and apply preservative oil to them.
8.6.7
Skid pads
•
Clean the skid pads after use with water and a mild soap solution.
•
Dry the skid pads and check them for wear and damage. Replace worn skid pads.
8.7
Yearly dealer maintenance
We recommend having the equipment inspected, checked, set and tested once a year by a Holmatro
Certified Technician who has the appropriate knowledge and the necessary tools (see also section 1.7).
The Holmatro dealer can organize the yearly maintenance for you on a contract basis.
9
Decommissioning/Recycling
At the end of its service life the equipment can be scrapped and recycled.
•
Make sure that the equipment is put out of order to avoid any use.
•
Check that the equipment does not contain any pressurized components.
•
Recycle the various materials used in the equipment such as steel, aluminium, NBR (Nitrile
Butadiene Rubber) and plastic.
•
Collect all dangerous substances separately and dispose of them in an environmentally responsible
way.
•
Consult the Holmatro dealer about recycling.
HSS 200
916.001.096_005
EN
37
Publicité
Table des Matières
