Holmatro HSS 200 Mode D'emploi page 27

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2.5
Safety regulations concerning the equipment
Never allow people to stand under a load.
Always position the equipment on a solid and level surface.
Make sure the accessories are installed correctly.
Only apply force onto the product in a perpendicular and axial direction.
Prevent any side and skew forces.
Never use this product without an appropriate saddle to prevent damage to the plunger.
The plunger must not come into contact with sharp objects. This can cause the seal to leak.
2.6
Safety regulations with respect to the operation of the system
Make a risk assessment of the procedure before you start work (EN-ISO 12100).
Keep bystanders at a distance and be extra careful in the vicinity of people and animals.
Make sure the work area is clearly laid out and has good lighting.
Avoid stress and work in a structured way. This reduces the risk of errors, combinations of dangers
and accidents.
Before use, check the equipment for damage. Do not use the equipment if it is not in good
condition, and consult your Holmatro dealer.
Hold the equipment only by its carrying handle (if present). Never use any part of the hose as
carrying handle.
Always use a pressure gauge to verify the pressure in the system.
Monitor the situation of the equipment and the structure continuously while using the equipment.
Do not lift unstable loads.
Never couple or uncouple couplers while the system is under pressure.
Use only genuine Holmatro accessories and ensure that they have been attached correctly.
Be extra careful when lowering a load (if applicable).
Make sure that parts of the body never come between moving parts. There is a risk that parts of the
body may be crushed or cut.
Stop immediately if the system makes strange noises or displays aberrant behaviour.
Stop immediately if the equipment leaks oil. Oil escaping under pressure can penetrate the skin and
cause serious injury. Go immediately to a hospital with a person who is injected with oil for medical
help. Give a specification of the oil to the medical staff.
Always adhere to the safety regulations that apply to other equipment that is used in the operation.
2.7
Safety regulations with respect to maintenance
Wear personal means of protection when performing maintenance tasks.
Never work in a way that could jeopardize safety.
Make sure that the equipment cannot roll away or tip over. The control and drive must be switched
off and safeguarded against unexpected activation.
Make sure that moving parts do not move unexpectedly.
Used or leaked fluids, and any other products consumed during the activities, must be collected and
disposed of in a environmentally responsible way.
HSS 200
916.001.096_005
EN
27

Publicité

Table des Matières
loading

Table des Matières