7. Display screen: display ECG waveforms and data.
8. Metal Electrode III
9.
ECG Lead wire connector: for connecting to lead wire.
10.
Data interface: for connecting Mini USB data cable.
1.2 Name and Model
Cardio-B bluetooth palm ECG with software
1.3 Structure
Cardio-B palm ECG monitor consists of main board, panels and electrodes.
1.4 Features
1. Small in size and light in weight to carry.
2. One-key measurement, easy to operate.
3. ECG waveform and interpretation of results are displayed clearly on dot-matrix LCD screen.
4. Seventeen types measurement result can be presented.
5. Up to 1200/2700 pieces of records for quick measurement, or 10-hour/22.5-hour data recording for continuous
measurement, the data storage depends on the provided size of the built-in memory.
6. Data records can be reviewed, copied, deleted, and uploaded as well.
7. Power saving technique with automatic shutting-down function.
8. Two AAA batteries are used to support more than 10 hours working time.
9.Wireless data upload function (optional).
1.5 Intended Use
Cardio-B palm ECG Monitor is intended for measuring and recording the ECG signal and average heart rate of adult
patient. It is applicable for use in clinics and homes, and convenient to operate by the patients themselves.
The device is not an ECG monitor as used in clinical institution or hospital, but is used for spot-check purpose ONLY.
It can not be used to substitute the normal ECG examination or real time monitoring. The measurement results are a
useful reference for doctor, but do not make direct diagnostic or analytical decision based on the information provided
by this device.
1.6 Operating Environment
Operating temperature 5~40°C
Operating humidity
Atmospheric pressure 70kPa~106kPa
2 Installation
1. Open the battery cover (see the right figure).
2. Insert two AAA size batteries directly.
3. Close the battery cover.
Do NOT insert batteries with their
polarities reversed. Dispose of the used
batteries according to applicable local
regulations.
Protecting films are attached to the
electrodes of device, so please remove
the protecting films before measurement.
3 Operation
3.1 Start to measure ECG
Press the Power button (lasting for 2 seconds) to
turn on the unit. The unit starts to initialize, and
displays the following pictures.
After boot-strap, the unit enters into menu screen,
as shown in Figure 3-2.
Note: During initialization, press "
button to enter into main menu screen, as shown
in Figure 3-2. If press "
ENGLISH
30%~80%
Return"
Measurement", it will
Figure 2
Figure 3-1A
20
Figure 3-1B