Operation Description - Gima PC-80B Manuel De L'utilisateur

"ECG Viewer Manager" for detailed operation procedure.). The data measured in wireless real-time transmission status
won't be stored in the unit.
3. If there is no operation after the continuous measurement has been carried out for 3 minutes, the unit will adopt power-
saving mode automatically (the screen will darken), but the measurement won't be interrupted. Once you press any
button or the alarm event occurs, the system will exit power-saving mode, and the screen resume to normal brightness.
Notes: 1) Figure 3-5 shows a regular ECG waveform measurement result, this
device can provide 17 types measurement results, refer to Table 3-1(Section
3.4.3) for details.
2) During measurement, if the measured part and metal electrodes loosely contact,
the device will prompt "Contact?", as shown in Figure 3-9. If there isn't signal, it
will prompt "No signal". The user can press "
measurement.
3) The device provides built-in 16MB/32MB memory clips (selecting "Memory" on
main menu screen to see the detailed memory space), at most 1200/2700 data
records for quick measurement or 10-hour/22.5-hour data records for continuous
measurement can be saved in this device, and when the device connects to PC
successfully, it works as a removable USB disk which contains four files, and 300/720
pieces of quick measurement can be recorded in each file.
4) When the storage space is full, the device will indicate and prompt that "Memory
full! Overwrite record?" with a display of "
Meanwhile, from now on, it won't store the new record until the user manually
deletes the unnecessary data or upload the records to PC to free some memory.
5) The device will power off automatically if there is no any key operation or signal
inputting for a while.
3.4 Wave Review

3.4.1 Operation Description

1. Select "Review" on main menu screen, then press "
device enters record list screen as shown in Figure 3-11
Note:
" ": means the measured result of this record is regular.
" ": means the measured result of this record is irregular.
" ": means waveform with interference or lead off during measuring.
" ": If the enhanced mode is used, the icon of enhanced mode will be
shown behind the record.
NOTE: There is no such legend icon display for the record of continuous measurement. Only the start
and end measuring time (not including the year) is displayed here.
2. Choose a record in record list, then press "
this ECG record, the waveform display for quick measurement and
continuous measurement are shown in Figure 3-12 and Figure 3-13
respectively. To stop auto replay, just press the Navigation key "
" or " / ". After that you can press the Navigation key "
" or " / " again to view the waveforms manually.
On-screen display:
1. "16: 14: 32": ECG waveform measuring time.
2. "X1": ECG waveform gain.
"X1/2": Waveform scaled with half of the basic gain;
"X1": Waveform scaled with basic gain;
"X2": Waveform scaled with twice of the basic gain
"X3": Waveform scaled with three times of the basic gain
3. "HR=66": heart rate value is 66bpm. For waveform review of continuous measurement, the heart rate value won't
ENGLISH
Return" button to exit from the
" mark as shown in Figure 3-10.
OK " button to review
OK " button, the
Figure 3-11 Record List
/
/
Figure 3-12 ECG Data Review Screen
(Quick Measurement)
24
Figure 3-9
Figure 3-10