hergom C-16/80 N Instructions D'installation, D'utilisation Et D'entretien page 18

4. DISASSEMBLY OF ELECTRICAL PARTS
BEWARE! Before handling the electrical parts,
make sure that the appliance is disconnected
from the power supply.
Follow these instructions to replace the fans:
1. Remove the four screws holding the front
of the fan tray (Fig.1).
2. Once the 4 screws have been loosened,
remove the tray supporting the fan (Fig.2).
Special care should be taken when removing
the tray not to cut or damage the wiring.
Hergom declines all responsibility for
defective installation or incorrect use and
reserves the right to modify its products
without prior notice.
The responsibility for manufacturing defects
will be subject to the criteria and verification
of its technicians, and in any case, will be
limited to the repair or replacement of its
products, excluding the works and damages
that such repair could cause.