Information On Saw Blades; Initial Operation; Fitting/Changing The Saw Blade; Fitting The Rip Fence - Parkside PSTD 800 B1 Traduction Des Instructions D'origine

Information on saw blades

Parkside basic equipment includes saw blades
principally for use with wood and metal.
▯ 3 saw blades for general wood cuts
▯ 1 saw blade for light metals up to 3 mm
NOTE
► You can use any saw blade, provided it is
fitted with a suitable mounting (single-lug
shank).
Saw blade type
suitable

Initial operation

Fitting/changing the saw blade

Always remove the plug from the power socket
before working on the appliance.
♦ Remove the pivoting blade guard
♦ Turn the quick-release chuck
this position.
♦ Push the required saw blade into the quick-
release chuck as far as the limit stop.
♦ Release the quick-release chuck
returns to its initial position. The saw blade is
now locked.
■ WARNING! The saw blade teeth must point
forwards at this point (see foldout page)!
♦ Replace the pivoting guard
appliance.
│ GB │ IE
■ 6

Fitting the rip fence

The rip fence
the appliance.
♦
♦
♦
Connecting the sawdust extraction
device
♦
unsuitable
♦

Fitting the sliding shoe

When working on sensitive surfaces, you can fit
the sliding shoe
scratching the surface.
♦
♦
.
and hold it in

Fitting the splinter guard

The splinter guard
face while sawing wood . The splinter guard
only be used for certain saw blade types, with the
so that it
sliding shoe
♦

Adjusting the laser

♦
back onto the
can be fitted on the left or right of
Undo both the clamping screws on the insertion
openings .
Push the rip fence into the insertion openings
Retighten the two locking screws.
Push the reducer into the extraction nozzle
until it is secured.
Attach an approved dust and sawdust extrac-
tor to the reducer or extraction nozzle
directly.
on the footplate
Mount the sliding shoe
and press it up at the back until it clicks into
place on the footplate
To remove the sliding shoe
rear of the footplate
can prevent fraying of the sur-
and only for cutting angles of 0°.
Press the splinter guard
sliding shoe (arrow facing upwards).
If the laser line is not vertical in the notch
can adjust it by adjusting the position of screw
.
to prevent
onto the footplate
.
, unfasten it at the
and slide it off the front.
can
from below into the
, you
PSTD 800 B1
.