Fagor NVP-300 P Manuel D'installation/Utilisation page 33

Reference editing
To edit the references, access the main menu using the
Depending on the value of PAR 64, the data protection option will request a password or not. This password is: 719200
If after requesting the code, ENTER is pressed, the values of references may be seen; but not modified.
Then, select the desired option (edit or delete) and enter the reference number followed by ENTER.
To change the value of the reference offset, press the key of the axis to be modified and preset the desired value followed
by ENTER to validate it.
To go from one reference to another, use the < > keys.
Edit the properties of the references
To change the radius/diameter property, just press the [½] key that toggles from one to the other.
To change the other properties of the reference, press the [REF] key. This will display the next menu.
Properties
<Direction> Swap X,Z
Selecting "Direction" will display the next screen.
Select axis & direction
X+ Z+
To change the counting direction, press the key of the desired axis and use the [+/-] key to toggle + and -.
Once adjusted, press ENTER to accept the change or CLEAR to cancel them and return to the reference editing screen.
If Swap X-Z is selected, it will ask whether the X and Z values are to be swapped or not.
Use the < > keys to choose the option and press ENTER to validate it.
- FAGOR AUTOMATION S. COOP -
key and select the Refs option.
F
- Page 2 of 5 -