Removing The Sim Card; Electrical Connections - MVG NeptuLink Manuel Utilisateur

Inserting a second SIM card:

REMOVING THE SIM CARD

Follow the steps below to remove either of
the SIM cards from your terminal.
➊
Switch the device off.
➋
Unscrew the center cover.
➌
Push in then release the SIM card to re-
move it from the slot.
➍
Screw the cover back on.
➎
Switch the device back on.
Never remove the SIM card when the
terminal is switched on, as this may
damage the card and/or the terminal.
8

ELECTRICAL CONNECTIONS

The terminal can be powered in two ways:
•
Power supply through the 12-24 V DC
socket.
•
24 VDC Power over Ethernet (PoE) con-
nection using a passive injector.
Stay at least 20 cm away from the termi-
nal when it is switched on.
If you have the PoE option, do not con-
nect the PoE injector and the standard
power supply at the same time.
For passive PoE power supply, do not
connect/disconnect the power cable when
the injector is on.
Before installing the terminal blocks and
plugging in, the cable(s) must be screwed
through the cable glands (one cable per
gland).
When using PoE, only one cable gland is
used. A cap (fitted with a nut) must be in-
stalled in the free hole of the plate to achieve
the sealing of the device.
EMI Suppressor Ferrites must be installed on
each cable, at the output of the device.
Typical Impedance on each cable:
3 k at 100 MHz
1.5 k at 25 MHz
(e.g. 12 ferrites No. 7427007 from Würth
Elektronik).