Updating The Terminal; Manual Updates; Remote Updates - MVG NeptuLink Manuel Utilisateur

•
Transmit power.
Ensure you comply with your country's
current regulations.
•
SSID - access point identifier.
•
Network security settings.
➍
Click Save & Apply to save and apply the
new settings.
➎
Reboot the terminal.

Updating the terminal

MANUAL UPDATES

Follow the steps below to update your ter-
minal manually.
➊
Click the System/Flash Firmware tab on
the upper band.
➋
Click Browse then select the update file.
➌
Click Flash image to start the process.
➍
A confirmation box is displayed. Click
Proceed to start the update process.
16

REMOTE UPDATES

Follow the steps below to update your ter-
minal remotely.
➊
Click the System/Firmware Upgrade tab
on the upper band.
➋
Click Check to check if a new version of the
software is available.
This may take a few seconds to complete.
➌
The result of this query may vary:
If there is a message showing:
•
"Not connected" means your terminal is not
connected to Internet and therefore cannot
check whether an update is available.
•
"No new firmware
means that the terminal is already running
the latest update version.
•
If an update is available, a strip containing
information on the new version is displayed
on the lower part of the interface.
➍
Click Perform upgrade to start the process.
➎
A confirmation box is displayed. Click OK to
start the update process.
version available"