Prerequisites; Required Sim Configuration; Getting Started; Inserting The Sim Card - MVG NeptuLink Manuel Utilisateur

Prerequisites

Ensure that you have the following items
ready before installing your terminal:
•
Active Internet access from a telephone
service provider (3G/4G data package).
•
Configuration settings for the SIM card(s) -
see below.
•
Computer configured for DHCP (Dynamic
Host Configuration Protocol, see appendix).

REQUIRED SIM CONFIGURATION

Depending on how your SIM card(s) are
configured, you will need one or more con-
figuration settings to connect your terminal
to the Internet:
•
APN setting (Access Point Name).
•
PIN code (Personal Identification Number).
Your telephone service provider should
have given you all the necessary infor-
mation to enable you to connect to the In-
ternet. Please contact your service provid-
er if you cannot find this information.

Getting started

Your terminal can be configured in five steps:
➊
Insert the SIM card(s).
➋
Connect the terminal.
➌
Install the terminal on its mounting.
➍
Configure the terminal.
➎
Connect to internet.
Ask your telephone service provider for
your SIM card's configuration settings be-
fore you start.
Ensure that you check the network cover-
age and compare the offers available
from different service providers.
Stay at least 20 cm away from the termi-
nal when it is switched on.

INSERTING THE SIM CARD

Follow the steps below to insert either of
the SIM cards into your terminal.
This terminal is designed to accept one or
two Mini SIM cards.
Using an incompatible SIM card may
damage your terminal or your card.
➊
Switch the device off.
➋
Unscrew the center cover to access the
SIM card slots.
➌
Insert the SIM card into its slot. The chip
must be positioned with its cut-off edge
facing towards the terminal, as shown in
the figure below. When using only one
chip, insert it in the slot marked "1".
➍
Screw the cover back on.
➎
Switch the device back on.
EN
7