Network Configuration; Changing Ip Address Configuration; Configure Dhcp Server - MVG NeptuLink Manuel Utilisateur

Network configuration

This section is intended for users with a
minimum knowledge in network configura-
tion.
In case of wrong configuration, perform a
"RESETTING TO FAC-
reset factory
TORY DEFAULTS".
CHANGING IP ADDRESS CONFIGURA-
TION
Follow the steps below to change your
terminal's network configuration.
➊
Click the Network/Interface tab on the
upper band.
➋
Click Edit to edit the LAN interface .
➌
From the "General" tab you can change
the network settings of the terminal (IP
address, netmask...).
➍
Click Save & Apply to save and apply the
new settings.

CONFIGURE DHCP SERVER

Follow the steps below to configure the
DHCP server.
➊
First follow the steps 1 and 2 of the pre-
vious section "
CHANGING IP ADDRESS CON-
".
FIGURATION
➋
A section at the bottom of the General
tab allows you to:
•
Enable/disable DHCP
•
Change IP address range
•
Define lease time.
➌
Click Save & Apply to save and apply
the new settings.
EN
17