Configuring The Modem; Changing The Modem Configuration; Other; Rebooting The Terminal - MVG NeptuLink Manuel Utilisateur

Configuring the modem

CHANGING THE MODEM CONFIGURA-
TION
In some specifics cases, it might be
necessary to change the modem configu-
ration to suit it with your network service
provider.
Follow the steps below to change your
terminal's modem configuration.
➊
Click the System/4G Modem tab on the
upper band.
➋
Select the firmware you want to use in the
Available Firmware drop-down list.
➌
Then, select one of the Available Configu-
rations for this firmware in the Available
Configuration drop-down list.
➍
Click Apply Configuration to start the mo-
dem reconfiguration.
➎
A confirmation box is displayed. Click OK to
start the process.
This may take a few seconds to complete.
18

Other

REBOOTING THE TERMINAL

➊
Click the System/Reboot tab on the upper
band.
➋
Click Perform Reboot.
➌
A dialog box is displayed. Click OK to re-
boot the terminal.
This can take 1-2 minutes.

RESETTING TO FACTORY DEFAULTS

➊
Click the System/Reset tab on the upper
band.
➋
Click Perform Reset.
➌
A dialog box is displayed. Click OK to reset
the terminal to factory defaults.

CHANGE LANGUAGE SETTING

➊
Click the System/Language tab on the up-
per band.
➋
Select a language from the language list.
➌
Click Save & Apply .
The change will be applied when reload-
ing the page from your web browser.