Topcom BPM WRIST 5331 WHO Manuel D'utilisateur page 9

3. Press the START/STOP button to start measurement. The cuff
will inflate to the level that is right for you.
4. When the right level is reached, the cuff will deflate.
This monitor will re-inflate automatically to
approximately 220mmHg if the system detects
that your body needs more pressure to measure
your blood pressure.
When the measurement is completed, systolic, diastolic and pulse
will be shown simultaneously on the LCD screen.
When the Systolic or the Diastolic pressure level has exceeded
the set maximum level, the display will light up RED.
RED light is a warning signal to suggest
you to consult your phsician.
When the Systolic or the Diastolic pressure level has not exceeded the set
maximum level, the display will light up Blue.
5. When a mistake was detected during measurement the Error icon
the display
14 Memory
The BPM 5331 has 3 Memory zones. Each can store up to 30
measurements including the date and time
The result will be stored automatically in the selected Memory Zone
after the measurement.
To recall measurement results:
• Press the START/STOP button to activate the display.
• Press the UP or DOWN button to select the desired memory
zone.
• Press the MEMORY RECALL button to see the average of the
last 3 measurement results [A]
• Press the MEMORY RECALL button repeatedly to see prior
stored measurement results.
• To stop reading the data, press the START/STOP button to
switch back to normal time.
TOPCOM BPM Wrist 5331 WHO
appears on
9