Unpacking And Connecting; Unpacking; Assembly - Dirt Devil VAPORFLEX M3101 Mode D'emploi

2 Unpacking and connecting

2 Unpacking and connecting

2.1 Unpacking

2.2 Assembly

3
2
2
2
2
1
Unpack the appliance and all accessory parts and check
that the contents are complete. Information regarding the
scope of delivery, ZPage 20, "An overview of your Vapor-
flex".
ATTENTION:
Always transport/send the appliance in its original pack-
aging so that it does not become damaged. Keep the
packing material for this purpose.
Dispose of any packing material that is no longer
required in accordance with the provisions applicable in
your country.
NOTE:
If you should notice damage due to transport, then con-
tact your dealer immediately.
WARNING:
Only assemble the appliance if the plug has been pulled
out of the socket and the accessory parts have cooled
down.
1
1. Insert the handle (Fig. 2/1) and the extension tubes
(Fig. 2/2) into each other. The locking catch clicks audi-
bly into place.
Fig. 2
NOTE:
You can take the tubes apart. To do this, press the
release button (Fig. 2/3) and pull the tubes apart.
2. Insert the jointed connection (Fig. 3/1), as shown, into
1
the floor nozzle (Fig. 3/2).
3. Turn it 180° to lock it. It is now securely connected to the
floor nozzle.
NOTE:
To loosen it, turn the jointed connection again by 180°.
Fig. 3
25