Mounting And Installation - Dantherm CDF 10 Manuel D'entretien

Mounting and installation

Suspension
The wall suspension bar supplied with the unit is fixed to the wall and the dehumidifier
is hung up on it. It is important to mount the unit in a horizontal position to secure cor-
rect outflow of the condensate water.
The dehumidifier must be placed in a way that allows unimpeded air intake through the
front and outlet through the grill on the sides. Be sure always to leave at least 100 mm
free space around the unit for optimum operation.
It is important that the dehumidifier is not installed near a source of heat as for example
a radiator, and doors and windows must be kept closed when the dehumidifier is in
function.
Installation of the
1) Place the CDF 10 on the wall by means of the wall suspension bar.
water tank
2) Then dismantle the front panel of the CDF 10.
3) Fix the water container cabinet by 4 machine screws under the bottom of the CDF
4) Take the supply cable through the diaphragm bush at the bottom of the water tank
5) The control of the CDF 10 is placed in a box behind the front panel. To get access
6) Take the cable from the magnetic switch through the diaphragm bush at the bot-
7) Remount the control box lid and the front panel.
8) Place the water tank in the water tank cabinet. The float must be turned towards
Drawing
The water tank is mounted beneath the CDF
10 as shown on the drawing:
10.
cabinet.
to the control, unscrew the 4 screws on the sides of the box and remove the box
lid.
tom of the CDF 10 and connect it to the terminal strip on the PCB – terminal points
13/14 (WATER SW).
the magnetic switch.
Continued overleaf
17