Product- And Functional Description - Dantherm CDF 10 Manuel D'entretien

Product- and functional description

Introduction
This section will give you a description of the CDF 10 and its functionality.
Description of
CDF 10 is working in accordance with the condensation principle. The humid air is
function
drawn into the unit by a fan. When passing through the evaporator the air is cooled
down to below dew point and water vapor is condensed into water, which is drained
away. The now dry air is then passed over the condenser coil where the air is heated.
As a result of the released evaporator heat and the working energy of the compressor
being turned into heat energy, more heat is returned to the air than was previously ex-
tracted. This extra heat corresponds to an approximate increase in temperature of 5 °C.
The repeated circulation of air through the unit reduces the relative humidity, giving
very rapid but gentle drying.
Air flow
The following illustrates the air flow:
Built-in hygrostat
The dehumidifier is controlled by
a built-in hygrostat that is set to
approx. 50 % RH. When the hy-
grostat registers a relative humid-
ity of more than 50 %RH, the
compressor and the fan auto-
matically switch on and the de-
humidifier starts to dehumidify.
The front panel has to be
removed before adjusting the
hygrostat. The hygrostat is
located under the control box and
can be adjusted by turning the
set screw.
Continued overleaf
15