afx light BEAM2R-X Manuel D'utilisation page 5

4
.3 FIXTURE CONNECT
Attention! One product only can accept one input one output.
BEAM-2RX DMX cable includes 3 contact pins:
Pin 1, for ground; Pin 2 connected to the negative polarity signal; the pin 3 connected to the positive polarity
signal.
DMX512 cable must use the professional shielded twisted pair cable; standard loudspeaker cable is not
reliable to control the long-range data. 24AWG cable is suitable for more than 300 meters long-distance
signal transmission and must add a DMX 512 signal amplifier.
Do not use two outputs to separate the connection, if separate a continuous connection to branch,
a DMX512 splitter is necessary.
If use the DMX512 splitter. At first connect DMX512 Splitter input terminal to controller,
and then connected from the splitter output terminal to next device.
Do as above guide to connect other device, and finally coupled with terminal insertion as following:
5- ALTERNATING CURRENT POWER SUPPLY
5.1 VOLTAGE, POWER, FUSE SPECIFICATION
~240V – 50/60Hz
Input Voltage: 110
Total power: 350W
Fuse: 6A / 250V - 5x20mm
5.2 POWER PROTECT
The equipment must be operated by professionals; Make sure that the voltage of power supply must be
comply with the voltage identified on the lamp, and must have an overload or leakage electrical
protection.
WARNING!
Factory has equipped the standard 3 pin plug socket.
If lamp cable is damaged, replacement should be operating by factory or qualified staff.
Any question, please contact professionals or talk to a qualified electrician.
©Copyright LOTRONIC 2016 BEAM2R-X Page 5