Safety Information - afx light BEAM2R-X Manuel D'utilisation

2. SAFETY INFORMATION

This product is only suitable for professional use, and does not apply to security for other purposes.
This product is only suitable for indoor, IP20 protection class. Lamps should be kept dry to avoid Moisture,
overheating or dusty environment. Prevent lamps come into contact with water or any other liquid.
The use of this product should pay attention to: fire, heat, electric shock, ultraviolet radiation, the lamp to
explode or Shedding caused serious or fatal injury.
Read the instructions prior to installing and using the product.
Follow through the operation of security methods and pay attention to the warning signs on the specification and
equipment. If you have any problem for to safely operate the equipment. Please contact your dealer.
2.1
ANTI-HIGH TEMPERATURE
ta = 40°C
Please don't use the equipment if the temperature above 40°C
2.2
BURST PREVENTION
The lens should be changed if had damaged or any problems. Don't change the non-original
manufacturer lens.
￠119mm×23mm
Len size:
2.3 TO PREVENT FALLING WOUNDING
Please don't move the package by one person only.
When Hang the fixture, please must verify that the facilities to be able to withstand the weight of the
lamps at least 10 times more.
Please make sure the Mounting hardware is strong enough no any damage, and insurance for the safety
rope as auxiliary security fixed in other facilities will need to verify before installation.
2.4
UV PROTECTION AND THE BULB EXPLOSION
Prohibit straight viewpoint with exposed bulbs to avoid UV damage to the eyes;
Do not use the equipment without the lens screen and the lid;
The lens and the light head covers should be timely replaced if any damage to rupture
The Fixture should be used with the protection screen together.
2.5
PREVENTION OF ELECTIC SHOCK
The electrical connection must only be carried out with corresponding qualifications;
Before installing, make sure you use the power voltage lamps must comply with the identified power, voltage and
have an overload or leakage protection;
Each lamp must be properly grounded, installed in accordance with the relevant standards;
Cut off the power when stall or replace the lamp and the fuse;
Prohibit the use of a lightning storm or wet environment.
2.6
TO PREVENT BURNING OR FIRE
1,The fixture can not be mounted directly on the surface of ordinary combustible material.
2.
Do not short-circuit temperature protection switch or fuse, use the specified type of fuse.
3.
The equipment must be installed away from inflammable and explosive materials.
4.
The equipment should be projected range of 3 meters away objects
©Copyright LOTRONIC 2016 BEAM2R-X Page 3