Setting The Transmission Sensitivity; Intercom Function To The Baby; Switching The Nightlight On/Off; Searching For The Parent Unit - switel BC-207 Mode D'emploi

Table des Matières

Les langues disponibles

4.5

Setting the transmission sensitivity

The transmission sensitivity from the baby unit to the parent unit can be adjusted in 5 steps. In Step 5, even very quiet noises can

be heard at the parent unit. In Step 1, only loud noises can be heard. If you want to be sure that you will hear all noises, use

Step 5.

Note: This setting has no effect on the visual indication of noise on the parent unit.

Press the

button once. The sensitivity currently set is shown on the visual display (12).

Now select the required sensitivity using the

seconds.

4.6

You can speak to the baby in order to calm it by using the intercom function. To do this, press and hold the TALK button (10) on

the parent unit and speak. You will be able to hear the baby again when you release the TALK button (10). The indicator light

(7/14) on both the parent and baby unit will flash while you are speaking.

Note: If the volume on the parent unit is switched off, this will be automatically reset to a medium volume.

4.7

You can switch the nightlight on the baby unit on and off by means of the

4.8

If you cannot remember where you have left the parent unit, press the PAGE button (2) on the baby unit. You will hear the call

signals from the parent unit and thus be able to find it again easily. You can cancel the audible signals prematurely by pressing

any button on the parent or mobile unit.

Note: If the volume on the parent unit is switched off, this will be automatically reset to a medium volume.

- Operation -

and

buttons (15). The selection will be automatically saved after a few

button (1).

Table des Matières

Table des Matières