Baby Unit - switel BC-207 Mode D'emploi

- Setting up -
Charging the parent unit
Place the parent unit in the charging station with the display to the front for at least 16 hours. The charge monitoring light on the
charging station will come on. The standard rechargeable batteries have an operating time of max. 12 to 24 hours at room
temperature.
If the battery capacity is too low, the BATT LOW indicator light (13) will flash and you will hear a warning tone every minute. The
parent unit must only be used for a further 1 hour after the first warning tone.
3.2

Baby unit

Connecting the power supply
Use the plug-in mains power supply provided for the baby unit. Insert the small round plug into the socket provided on the rear of
the baby unit (9) and plug the power supply into a mains socket (230V/50Hz). Ensure that the plug-in mains power supply is
adequately ventilated.
Fitting batteries as a backup in the case of supply failure or for battery mode (not included)
The baby unit is designed for operation with the plug-in mains power supply provided. The baby unit can be operated with four
1.5V AA alkaline batteries as a backup in the case of supply failure or for short-term operation in battery mode. In this case, the
baby unit can be used for 16 hours with new batteries.
If the battery capacity is too low, the BATT LOW indicator light (4) will flash and you will hear a warning tone every minute. The
parent unit must only be used for a further 1 hour after the first warning tone.
Open the battery compartment on the rear using a coin and insert the batteries. When doing so, take care to ensure that the
polarity is correct and close the battery compartment.
51