HWAM Autopilot IHS 7100 Série Manuel D'utilisation page 10

• The smoke shelf (5).To be placed on top of the steel rail and on the holders in the sides.
• Two-piece smoke defector plate (6). Each half is hung on the hooks located beneath the top plate.The two
halves join in the holders behind the air pipe. Once the stove has been installed, twist the protection off
the two hooks by using pliers or a screwdriver.
• Removable rear plate (2).This must always be mounted if the stove is placed next to a combustible wall.
• Loose heat shield (8) under the ash pan.This can be used as a lid when the ash pan is removed for
emptying.
Connecting and preparing the HWAM Autopilot IHS
1. Connect the plug
a) to a normal 230V socket
b) to the Air box in the wood section underneath the combustion chamber (lead the plug through
the air slot at the bottom between the side and rear plates - on the left side of the wood-burning
stove when seen from the front. There is a mark on the Air box where the plug should be let in.
See the photo of the power supply on the Air box.
Air box without power supply.
2. Insert three AA batteries in the remote control. When the IHS logo disappears from the display, the
remote control is ready to use.
3. The remote control and the wood-burning stove must be connected (the factory will see to this).
If the status line at the bottom of the display is clear (empty) (
into three sections, the wood-burning stove and the remote control are connected.
If the status line is dotted (
are not connected. Start with a display in which the light is off, and make the connection by pressing
and holding down the button, so the advanced menu is displayed. Then press the button repeatedly in
short intervals until the text "Link to stove" is highlighted and wait until it enters this menu. Press the
button in short intervals until the text "Connect" is highlighted and wait again. When the text "Please
cycle stove power" appears on the display, disconnect the electricity from the Air box and then recon-
nect. Press the button once more. If the message "Connected to stove" shows up in the display, the
wood-burning stove and the remote control are connected. Press the button once to return to the
main menu. If you do not press the button again, the remote control automatically leaves the menu
and returns to the start display.
4. Go through the self-test of the HWAM Autopilot IHS
The self-test of the electronic control is carried out before lighting the first fire in the stove (the
factory will see to this). The self-test can only be done when the wood-burning stove is cold and in
standby mode (no signal in the status line
not active, i.e. there should be no light in the display (
display before you hold down the button for a while, you will instead prepare the wood-burning stove
for lighting (the matchbox will appear in the display) and no self-test can be carried out.
Press the remote control button for approx. 5 seconds in order to enter the menu. Press the button
until the cursor reaches "Self-test". Wait a few seconds till the remote control enters the "Self-test"
menu. Press the button till the cursor reaches "Engage". A few seconds later the self-test begins.
By going through a self-test you ensure that all basic operations function correctly.
TM
Air box with power supply.
), the remote control and the wood-burning stove
:
TM
10
) and divided
). Make sure that the display is
). If there is light in the