Progress PAI8105I Notice D'utilisation page 13

Problem
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
Residual heat indicator does
not come on.
Automatic Heat Up function
does not operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
comes on.
comes on.
Possible cause
The fuse is blown.
You touched 2 or more sen‐
sor fields at the same time.
STOP+GO function oper‐
ates.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
You put something on the
sensor field .
The zone is not hot be‐
cause it operated only for a
short time.
The zone is hot.
The highest heat setting is
set.
Power management function
operates.
The cookware is too large or
you put it too near to the
controls.
Automatic Switch Off oper‐
ates.
The Child Safety Device or
the Lock function operates.
Progress 13
Remedy
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Activate the hob again and
set the heat setting in less
than 10 seconds.
Touch only one sensor field.
Refer to "Daily use" chapter.
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated suffi‐
ciently long to be hot, speak
to an Authorised Service
Centre.
Let the zone become suffi‐
ciently cool.
The highest heat setting has
the same power as the func‐
tion.
Refer to "Daily use" chapter.
Put large cookware on the
rear zones if possible.
Deactivate the hob and acti‐
vate it again.
Refer to "Daily use" chapter.