Zigzag Stitching; Adjusting Stitch Width And Length; Satin Stitch; Placement Of Patterns - Singer XL-400 Manuel D'instructions

ZIGZAG STITCHING

SETTINGS :Presser foot - General Purpose Foot
:Thread tension control - S
The top thread may appear on the bottom depending on the
thread, fabric, type of stitch and sewing speed, but the bobbin
thread must never appear on the top of the fabric.

ADJUSTING STITCH WIDTH AND LENGTH

is values set automatically when pattern (No. 03) is set.
The stitch length is 2 mm and the stitch width is about 5 mm.
is the selection range when setting the value manually.

SATIN STITCH

This is a closely spaced stitch used for appliqué, bar-tacking,
etc. Slightly loosen the top thread tension for satin stitching.
Set the stitch length between 0.5 and 2.0, depending on the
weight of thread being used.
Use a backing of stabilizer to help avoid stitches puckering the
fabric.

PLACEMENT OF PATTERNS

Stitch width of pattern increases from center needle position
as illustrated.
36
Under side
Côté de dessous
Reverso
Top side
Côté de dessus
Cara
STITCH WIDTH
LARGEUR DU POINT
ANCHO PUNTADA
mm 0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0 5.5 6.0 6.5 7.0
0
0.3
0.5
0.8
1.0
1.3
1.5
1.8
2.0
2.5
3.0
Center position
Position centrale
Aguja posicionada en el centro