Güde GDS 150 L Traduction Du Mode D'emploi D'origine page 22

ENGLISH
22
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool' s opera-
tion. If damaged, have the power tool repaired before
use. Many accidents are caused by poorly maintained
power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use of the power tool for operations
different from those intended could result in a hazar-
dous situation.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
Safety instructions Duplex grinding
machine
Operation is only allowed with a safety
switch against stray current (RCD max. stray
current of 30mA).
The machine must be plugged to 230 V with 16
A fuse.
wear ear protectors. Exposure to noise can cause
hearing loss.
wear protective glasses
wARNING The dust produced when using this tool may
be harmful to health. Do not inhale the dust. Use a dust
absorption system and wear a suitable dust protection
mask. Remove deposited dust thoroughly, e.g. with a
vacuum cleaner.
The power tool must stand or be fixed to a horizontal and
level surface (e.g. work table)
Switch the machine off and unplug it when unattended.
Check all screw and plug-in connections and
protective equipment if firm and tightened
properly and whether all moving parts are
running smooth whenever the appliance is to be
put into operation.
The protective equipment on the appliance is
strictly prohibited to be disassembled, changed,
used in conflict with the designation and it is
prohibited to attach any protective equipment of
other manufacturers.
The appliance must not be used if damaged
or safety equipment is defective. Replace any
worn-out and damaged parts.
Any defect on the power tool, including on the protective
equipment or abrasive wheel must be reported to a safety
engineer immediately after it is identified.
before use check machine, cable, and plug for any dama-
ges or material fatigue. Repairs should only be carried out
by authorised Service Agents.
Make sure the abrasive wheel is fitted properly before
pressing the On/Off button.
To make sure the work is safe, use equipment such as
power tool supports, magnifying glass, workpiece holder,
etc.
Removing sawdust and chippings from the machine
when running is strictly prohibited.
Do not use blunt, damaged or distorted circular saw
blades.
Choose the abrasive wheel suitable for the given work-
piece.
Abrasive wheels not corresponding to the characteristics
given in these Operating Instructions may not be used.
The maximum revolutions given on the abrasive wheel
must be respected.
Familiarise with the safety procedures for cleaning,
maintenance and regular removal of sawdust and dust to
reduce the risk of fire.
Make sure the flange used is suitable for the given purpo-
se of use, as specified by the manufacturer.
The power tool must immediately be switched off if it
gets blocked. Unplug the power tool and remove the
stuck workpiece.
At frequent intervals, check the adjustment of the
protection against sparks and set the abrasive wheel
wear properly. Keep the distance between the protection
against sparks and the abrasive wheel small if possible
(max. 2 mm).
At regular intervals, check the workpiece support adjust-
ment and set the abrasive wheel wear properly.
Do not grind with a cold abrasive wheel. Let the abrasive
wheel run idle for one minute before starting your work.