Transporting The Appliance; Troubleshooting; General Faults - SilverCrest SGW 860 A1 Mode D'emploi

14. Transporting the appliance

Always transport the appliance vertically, wherever possible. If necessary, it is also possi-
ble to transport the appliance on its back.

15. Troubleshooting

Fault
The appliance
does not start.
Water was not
pumped out of
the dishwasher.
Fault
Foam in the
appliance
86 - English
Technical faults
Possible cause
Fuse defective or circuit
breaker tripped
Appliance door is not ful-
ly closed
Power supply interrupted
Drain hose is kinked
Filter (5) blocked
Drain blocked

General faults

Possible cause
Incorrect detergent
Solution
 Change the fuse or switch on the
circuit breaker again. Make sure
that the electric circuit is protected
with at least 10 ampere.
 Switch the appliance on.
 Close the door correctly. It must
audibly click into position.
 Connect the mains plug (20) to a
socket correctly.
 Route the hose so that it is not
kinked.
 Clean the filter (5) regularly.
 Check the drain. Make sure the
drain hose is properly installed.
Solution
 Only use detergent that is suitable
for household dishwashers.
 If foam has formed, open the ap-
pliance and wait approx. 20–30
minutes until the foam has reced-
ed.
 Fill the water tank with 1.5 l wa-
ter and allow the water to drain
manually.
 If necessary, repeat the process
several times until the foam has
been rinsed away.