Installation; Setup And Levelling; Connecting To A Water Supply - SilverCrest SGW 860 A1 Mode D'emploi

8. Installation

WARNING!
Risk of electric shock and material damage!
There is a risk of electric shock as well as material damage
if the appliance is connected improperly.
 The electricity and water supply should only be connect-
ed by a qualified expert.

8.1. Setup and levelling

 Install the appliance on a stable, flat surface close to a drain and water connection:
− on a table/work surface
− in a ventilated cupboard.
 Only connect the mains plug (20) to a properly installed and freely accessible socket if
the water supply and outlet have been connected correctly (see next section).

8.2. Connecting to a water supply

Before adding water, press the
NOTICE!
Damage to the appliance!
If the appliance is connected improperly, there is a risk of
damage to the appliance.
 The hose must be free of kinks and connected carefully.
 Connect the water supply hose (21) to a cold water tap with a 3/4" thread (see Fig.
D). You can also connect the supply hose to a hot water tap if the water temperature
does not exceed 70 °C.
This reduces wash time by about 15 minutes.
 Screw the hose connection hand tight.
The water hose is designed for a water pressure of up to 10 bar. We recommend closing
the water supply off after use, especially if your house connection does not have a pres-
sure reducer.
66 - English
button (18) to switch on the dishwasher.