Changing The Program; Opening During Operation; Risk Of Burning - SilverCrest SGW 860 A1 Mode D'emploi

10.3. Changing the program

You can only change the program if the appliance has been operating for a short time. If
the appliance has already been running for a longer time, the detergent and water must
be replenished and the required program must be restarted.
 Press the
button (13) to interrupt the program.
 Press the P button (17) for approx. 3 seconds until the appliance switches to standby
mode.
 Then select another program: To do so, press the program selection button P several
times until the operating light(s) for the required program light(s) up.
 Press the
button (13) again to start the program.
The program starts after approx. 10 seconds.

10.4. Opening during operation

CAUTION!

Risk of burning!

Hot water/hot steam can escape and cause burns if the
door is opened while a program is running.
 Do not open the dishwasher door fully straight away
– instead wait for about 3 seconds until the spray arm
stops rotating and then open the door completely.
The door can be opened while a program is running, allowing more dishes to be load-
ed or others to be removed. This is only efficient if the program has only been running for a
short time, as otherwise the newly loaded dishes might no longer be fully cleaned.
 While the program is running, press the
spray arm stops rotating and then open the door.
 Load the additional dishes and/or remove items.
 Close the door again fully. Press the
The program continues after approx. 10 seconds.
78 - English
button (13). Wait about 3 seconds until the
button (13) again to continue the program.