SilverCrest SGW 860 A1 Mode D'emploi page 68

 Secure the hose end so that the hose cannot slip (see Fig. H).
8.4.2. Feeding the hose into an outlet pipe
NOTICE!
Possible material damage!
Material damage is possible in the event of water leakage.
 Make sure that the outlet hose is always introduced into
an outlet at a height of 60 cm, as otherwise the pump ca-
pacity would be impaired.
 Under no circumstances may the hose end lie under wa-
ter.
 Ensure that the supply and drain hoses are not kinked or
crushed.
 You can also feed the drain hose into a drain pipe. Mount the hose in the outlet pipe in
such a way that it cannot come loose and that water can flow downwards freely.
 The drain hose can be extended by max. 100 cm. Use an extension with an internal di-
ameter that is at least the diameter of the original hose or a suitable connecting piece.
 The hose extension should run along the floor – only the pipe section in the proximity of
the outlet point should run upwards.
8.4.3. Running the hose into a sink/container
 Hang the end of the drain hose into a sink (see Fig. I) or an appropriately sized con-
tainer (see Fig. J).
 Ensure that the drain hose is inclined sufficiently. The appliance is to be positioned at
least 4 cm higher than the sink/container.
68 - English
Fig. I Fig. J