Connections; Before Connecting Components; Connecting Other Components - Yamaha RX-SL100RDS Mode D'emploi

CONNECTIONS

Before connecting components

CAUTION
Do not connect this unit or other components to the mains power until all connections between components are complete.
• Make sure that all connections are made correctly - that is to say, L (left) to L, R (right) to R, "+" to "+" and "–"
to "–". Some components require different connection methods and have different jack names. Refer to the operating
instructions for each component you wish to connect to this unit.
• After you have completed all connections, check them again to make sure they are correct.
• The jack names correspond to the names on the input selector.

Connecting other components

Connecting a TV
Connect one end of the SCART cable to the TV/IN OUT connector on this unit and the other end to the SCART
connector on your TV.
Connecting AV components
Connect one end of the SCART cable to the EXT. IN/OUT connector on this unit and the other end to the SCART
connector on your AV component. You can also daisy chain several SCART components together as shown in "Digital
audio connections" (page 13).
AV component
(DVD player, cable tuner, etc.)
AM ANT GND FM ANT
75Ω UNBAL
TUNER
OPTICAL COAXIAL
DIGITAL
INPUT
1 2 3
DVD DTV
VIDEO 1
/CD /CBL
Note
Use a SCART cable to make the above connections. The SCART cable, or "Euro AV cable", supports IN/OUT signal transmission,
providing you with the best possible picture and sound.
12
CONNECTIONS
EXT. IN/OUT TV IN/OUT
OUTPUT
SUBWOOFER
TV
SPEAKERS FRONT CENTER SURROUND SURR BACK
R L R L
+ +
– –
MAINS