3M BPEO Taille 0 Instructions De Montage page 5

9. Fiber routing
9.1. Use of enclosed routing accessories
Fibers are maintained along their route by red colored plastic holders witch are installed on their pins by using the red
colored plastic stick (Pic 18-19). When not used the red plastic stick can be parked acc. to Pic 19.
The set of holders and tool are clipped on the clear plastic cover of the last installed splicing tray (Pic 20).
Stick
Holders
Hook for storing the
stick
9.2. Holding and routing the cable tubes or micro structure modules
Pay attention to the position of the holder on guiding pin (see below Pic). Position then push the holder using the stick on
the guiding pins in order to fix the loose tubes / micro modules in place. Tubes / micro modules are routed in between the
guiding pins; they should protrude at least 10 mm beyond the red holder.
Holder polarity: plastic hooks on the top
Remove the fiber tube so that at least 10mm of the tube will protrude outside the red holder.
Nota: It is recommended to start with the fibers to be spliced or stored in the first tray located in front of the
slack storage area.
Unused set of
18
Partially used set
5
Row on plate tray
19
20
Guiding pins
10mm