De)Activating Datalogging; Setting Clean Bar Warning Level (Expert Mode); Commissioning The Anti-Static Bar With A 24 V Power Supply - ITW SIMCO ION Performax IQ Easy Mode D'emploi

- [ (n)x

6.8 (De)activating Datalogging

If desired, the Manager can log data regarding the operation of the bar.
To (de)activate this data logging, the parameter Datalogging has to be changed.
For detailed information on datalogging, please refer to the manual Manager IQ Easy.
- [ (n)x

6.9 Setting clean bar warning level (expert mode)

After calibrating the bar (6.3), the IQ Easy bar will continuously monitor the effectiveness of the
bar. Should the effectiveness get below the set Clean bar warning level due to dirt, covering or
other cause, a warning (orange LEDs on the bar and orange background for the icon on the
Manager) will be generated on the Manager.
By default, this level is set standard to 50 %, but it can be set to a different value in specific
cases.
- [, , (n)x
desired value and confirm with

6.10 Commissioning the anti-static bar with a 24 V power supply

If the bar is connected to a 24 V power supply without the Manager, the bar will not have IQ
functionality. The bar can however be switched on/off remotely with the pin on the M12
connector and feedback will be provided on whether the high voltage is active on the
corresponding pin of the M12 connector (see figure 7).
- Remove the protection cover of the anti-static bar.
- Switch on the power supply of the anti-static bar.
- Connect 24 V DC to the Remote On/Off input of the bar*.
- When 24 V DC supply voltage is connected and the Remote On/Off input is activated, the
anti-static bar will be switched on.
* With a desktop power supply provided by Simco-Ion, the Remote on/off is already connected internally with the
24 V supply voltage. If this power supply is used, the bar will hence be activated as soon as the power supply is
switched on.
PerformaxIQEasyPerformaxIQEasySpeed_UM_9752154110_NL_D_GB_FR_V1_5
"Remote on/off source"
"Data logging"
select On or Off ]
"Clean bar warning level"
]
select Remote or Fieldbus ]
slide slider or with to the
GB
69