Operating Modes (Expert) - ITW SIMCO ION Performax IQ Easy Mode D'emploi

- Calibration is started,
The status LEDs on the bar are flashing yellow
and the status changes to a warning:
When the calibration is finished, the progress
indication will disappear, the warning be cleared
and the status LEDs on the bar light up green
(continuous= ionisation on).
It is not allowed to select other menu choices
during calibration.
After calibrating the date and time of the Last calibration date will be updated on the
information page.

6.4 Operating modes (expert)

The bar has 4 operating modes:
1 Fixed
The bar has a fixed ionisation. Ionisation works like a Performax Easy bar. A fixed number of
positive and negative ions are produced. Depending on the application, the static charge will
be neutralised and residual charge will remain.
2 Manual
For test applications or very specific applications the ratio between positive and negative ions
can be set manually. This is done by entering a ratio number. Usually, an even number of
positive (+) and negative (-) ions will be produced = 50/50 (fixed).
By entering a number other than 50, e. g. 60, 60 % positive and 40 % negative ions are
produced.
3 CLFB (Closed Loop FeedBack)
For this mode a Sensor bar IQ Easy bar has to be connected to the platform. After the film or
object to be neutralised has passed the Performax IQ Easy, the sensor will measure the
residual charge. This value is communicated to the ionisation bar which will regulate the ratio
of positive and negative ions automatically, so that the residual charge will be as close to
neutral (0) as possible.
4 Auto tune (not yet available)
To select the different modes, go to expert mode 6.2
(if not selected earlier):
- Click on the Information tab of the
Performax IQ Easy [
- Click on the settings button
PerformaxIQEasyPerformaxIQEasySpeed_UM_9752154110_NL_D_GB_FR_V1_5
]
66