Shure GLX-D Guide De L'utilisateur page 6

Transmitters
① Antenna
Carries wireless signal.
② Status LED
LED color and state indicate transmitter status.
③ Power Switch
Turns the transmitter on/off.
④ TA4M Input Jack
Connects to a 4-Pin mini connector (TA4F) microphone or instrument cable.
⑤ Micro USB Charging Port
Connect to USB battery charger.
⑥ Link Button
- Press and hold within 5 seconds of power-on to manually link with receiver
- Press momentarily to activate Remote ID function
⑦ Battery Compartment
Holds 1 Shure rechargeable battery.
⑧ Microphone Cartridge
GLXD-2 transmitter models are available with the following cartridge types: SM58,
Beta 58, SM86, Beta 87A.
Transmitter Status LED
LED is green during normal operation.
LED color or flashing indicates a change in transmitter status as shown in the follow-
ing table:
Color State
Green Flashing (slow)
Flashing (fast)
Flashes 3 times
Red On
Flashing
Red/Green Flashing
Amber Flashing
Wearing the Bodypack Transmitter
Clip the transmitter to a belt or slide a guitar strap through the transmitter clip as
shown.
For best results, the belt should be pressed against the base of the clip.
6
Wearing the Headworn Microphone
• Position the headworn microphone 13 mm (1/2 in.) from the corner of your mouth.
• Position lavalier and headworn microphones so that clothing, jewelry, or other
Status
transmitter attempting
relink with receiver
unlinked transmitter
searching for receiver
indicates locked trans-
mitter when power
switch is pressed
battery life < 1 hour
battery life < 30
minutes
remote ID active
Correct Microphone Placement
battery error, replace
battery
• Hold the microphone within 12 inches from the sound source.
• For a warmer sound with increased bass presence, move the microphone closer to
• Do not cover grille with hand.
4 3
1
off on
7
items do not bump or rub against the microphone.
the sound source.
2
8
GLXD2 2
on
3
5
5
6
6
7
1
13 mm
(.5 in.)