Commissioning Of The Model Helicopter; Charging The Flight Battery - Reely SKY 23 96 67 Mode D'emploi


10.

Commissioning of the Model Helicopter

a) Charging the Flight Battery
The flight battery can either be recharged via the transmitter
or the included USB cable.
Charging via transmitter:
The battery chute (1) protected against polarity reversal for
the flight battery (2) is located on the bottom of the
transmitter.
Slide the discharged flight battery into the charging chute
and observe that the two guide rails of the flight battery (3)
are directed downward and therefore interlock with the
battery chute (4) guides.
When you have pushed the flight battery into the charge
chute to the stop (see lower illustration of figure 7), switch
on the transmitter with the function switch (also see figure
1, item 6).
40
The display shows the regular operating display (see
figure 3), as well as the charge indication „CHG" to signal
correct charging of the flight battery.
The flight battery voltage is displayed on the transmitter
display during charging.
When the flight battery is fully charged, the additional
display „FULL" appears in the display.
Then disconnect the flight battery from the transmitter
immediately and switch off the transmitter again.
Figure 8
Figure 7