Reely SKY 23 96 67 Mode D'emploi page 49

Roll trimming (modes 1 and 2):
If the helicopter tends to drift or tilt to the right, reduce the speed until the helicopter is standing on its skids again
safety, and then push the left of the two trim buttons for the roll function repeatedly. If the helicopter drifts to the left,
push the right trim button for the roll function.
The transmitter emits a short confirmation tone at each push of a button. When the trimming is retuned to
the centre position, a double signal sound is emitted.
Additionally, the current setting of the trimming is displayed
with a trim bar in the lower right of the display. When the left
trim button is pushed, the marking arrow moves to the right;
when the right trim button is pushed, the arrow moves to
the right.
The last trim value set is automatically saved and displayed
again after transmitter is switched on again.
Push the pitch lever carefully forward and check if the
adjustment was sufficient.
Repeat the procedure until the model does not show any
tendency to drift to the right or light.
Figure 22
Figure 23
49