Fitting The Sandpaper Disc; Lubrication; Refilling Oil; Connecting To A Compressed Air Source - Parkside PDEXS 150 B2 Traduction Des Instructions D'origine

Fitting the sandpaper disc

GB
IE
CAUTION!
► Ensure that the appliance is disconnected
from the compressed air source before you
fit or remove a sandpaper disc
♦ The sanding disc
discs are equipped with matching Velcro
fasteners.
♦ Select the sandpaper disc
grain and press it onto the sanding disc
Ensure that it is centred.
♦ To change the sandpaper disc
side and pull it off the sanding disc
Clean the sanding disc
compressed air.

Lubrication

NOTE
► To avoid friction and corrosion damage,
regular lubrication is particularly important.
We recommend using a suitable special oil
for compressed air appliances (e.g. Liqui Moly
compressor oil).
–
Lubrication with mist oiler
–
A mist oiler (not supplied) continuously
and optimally lubricates the appliance as
a preparation stage after the pressure re-
ducer. A mist oiler gives off fine drops of
oil into the air flow and thus guarantees
a regular lubrication.
–
Manual lubrication
–
If you do not have a mist oiler, lubricate
the appliance before every use or longer
work sessions by dripping 3–4 drops of
special oil for compressed air appliances
into the connector nipple
8
.
and the supplied sandpaper
with the desired
.
, lift it from the
.
as required with
.
Refilling oil
To ensure that the compressed air-powered random
orbital sander remains operational for as long as
possible, make sure that there is sufficient pneu-
matic oil in the appliance.
The following options are available:
♦ Attach a maintenance unit with an oiler to the
compressor.
♦ Install a fitted oiler into the compressed air line
or the compressor.
♦ Add 3–5 drops of pneumatic oil into the con-
nector nipple
every 15 minutes of operation.

Connecting to a compressed air source

NOTE
► Before connecting the compressed air source
–
the correct working pressure (3–6 bar)
must be fully reached
–
make sure that the trigger is in the upper
position
♦ Attach the appliance to a compressor by con-
necting the connector nipple
hose of the compressed air source.
♦ To ensure that you can regulate the air pressure,
the compressed air source must be equipped
with a pressure reducer.
with the supply
PDEXS 150 B2