Pin Code Lock - Jaga Helios electric Manuel D'installation Et D'utilisation

14.2.2. PIN code lock
The heating device is protected by a safety code against nonauthorised use. The PIN code (Personal
Identity Number) is a customisable 4 numbers code.
14.2.2.1. PIN code initialisation
By default, the PIN code is not enabled. 'OFF' appears on the display.
1 2
14.2.2.2. (De)Activation of the PIN code
'OFF' appears on the display.
14.2.2.3. Customizing the PIN code
1 2
10. Press again to exit setting PIN code mode and go back to the home display of the installer
settings.
14.2.3. Restoring factory settings
In order to a coming back to factory settings, proceed from the setting of the customizing PIN code
setting, press .
1. 'Rest' appears on the display, press
2. 'NO' appears. Press
- YES: factory settings reset
- NO: factory settings not reset
3. Press for 5 seconds. The device returns to its initial configuration and goes back automati-
cally to the home display of the user settings.
Press twice to exit the Installer settings.
3. By default registered PIN code is 0000. Press
Save by pressing .
4. When 0000 appears, press
The PIN code is initialized, the next setting automaticaly appears PIN code
activation.
5. Press or to select 'ON' or 'OFF'.
- ON: PIN code enabled
- OFF: PIN code disabled
6. Press to save and return to the home installer settings display.
7. When 'ON' appears, press
8. The 0000 code appears and the first number blinks. Press
to select the first desired number then press
this operation for the remaining 3 numbers.
9. Press to confirm. The new code is now saved.
.
or to select 'YES'.
or
to save and exit.
for 5 seconds.
to save and exit. Repeat
to select 0.
EN
or
5 sec
85